search for ccna answer

Sunday, September 19, 2010

Year 2010 EWAN Final Exam : Accessing the WAN (Version 4.0)

1
Which encapsulation protocol when deployed on a Cisco router over a serial interface is only compatible with another Cisco router?

PPP
SLIP
HDLC
Frame Relay

2
What is a characteristic feature of a worm?

exploits a known vulnerability
attaches to executable programs
masquerades as a legitmate program
lies dormant until triggered by an event, time, or date

3
An administrator is configuring a dual stack router with IPv6 and IPv4 using RIPng. The administrator receives an error message when trying to enter the IPv4 routes into RIPng. What is the cause of the problem?

When IPv4 and IPv6 are configured on the same interface, all IPv4 addresses are over-written in favor of the newer technology.
Incorrect IPv4 addresses are entered on the router interfaces.
RIPng is incompatible with dual-stack technology.
IPv4 is incompatible with RIPng.

4
Which statement accurately describes a characteristic of a security policy?

It creates a basis for legal action if necessary.
It should not need altering once it is implemented.
It provides step-by-step procedures to harden routers and other network devices.
It is kept private from users to prevent the possibility of circumvention of security measures.

5
Which characteristic of VPN technology prevents the contents of data communications from being read by unauthorized parties?

QoS
latency
reliability
confidentiality

6
Refer to the exhibit. A network administrator is configuring Frame Relay on router HQ. It is desired that each Frame Relay PVC between the routers be in a separate subnet. Which two commands on HQ will accomplish this task for the connection to R1? (Choose two.)

HQ(config)# interface S0/0/0
HQ(config)# interface S0/0/0.1 multipoint
HQ(config)# interface S0/0/0.1 point-to-point
HQ(config-subif)# frame-relay interface dlci 103
HQ(config-subif)# frame-relay interface dlci 301
HQ(config-if)# frame-relay map ip 172.16.1.1 255.255.255.0 301 broadcast

7
Refer to the exhibit. Router1 and Router2 are directly connected over a point-to-point serial link. Router1 initiates a PPP session with Router2. Which statement is true based on the configuration?

The password is sent in clear text.
The routers are unable to authenticate.
The username and password are sent encrypted.
A hash value of the username and password are sent.

8
A technician has been asked to run Cisco SDM one-step lockdown on the router of a customer. What will be the result of this process?

Traffic is only forwarded from SDM-trusted Cisco routers.
Security testing is performed and the results are saved as a text file stored in NVRAM.
The router is tested for potential security problems and any necessary changes are made.
All traffic entering the router is quarantined and checked for viruses before being forwarded.

9
Which two statements are true about creating and applying access lists? (Choose two.)

There is an implicit deny at the end of all access lists.
One access list per port, per protocol, per direction is permitted.
Access list entries should filter in the order from general to specific.
The term "inbound" refers to traffic that enters the network from the router interface where the ACL is applied.
Standard ACLs should be applied closest to the source while extended ACLs should be applied closest to the destination.

10
Refer to the exhibit. Company ABC expanded its business and recently opened a new branch office in another country. IPv6 addresses have been used for the company network. The data servers Server1 and Server2 run applications which require end-to-end functionality, with unmodified packets that are forwarded from the source to the destination. The edge routers R1 and R2 support dual stack configuration. What solution should be deployed at the edge of the company network in order to successfully interconnect both offices?

a new WAN service supporting only IPv6
NAT overload to map inside IPv6 addresses to outside IPv4 address
a manually configured IPv6 tunnel between the edge routers R1 and R2
static NAT to map inside IPv6 addresses of the servers to an outside IPv4 address and dynamic NAT for the rest of the inside IPv6 addresses

11
A company uses a PVC with a committed information rate (CIR) of 128 kb/s and a committed burst information rate (CBIR) of 64 kb/s. The link is used to periodically send updates at a rate of 144 kb/s. What will happen to the update traffic?

The traffic will be sent, but the company will be charged a penalty.

The traffic will be sent using the additional CBIR and will be guaranteed delivery.

The traffic will be dropped at the CO for exceeding the committed information rate.

The traffic will be sent, but the burst traffic will be marked for discard if congestion is encountered.

12
Refer to the exhibit. All devices are configured as shown in the exhibit. PC1 is unable to ping the default gateway. What is the cause of the problem?

The default gateway is in the wrong subnet.
STP has blocked the port that PC1 is connected to.
Port Fa0/2 on S2 is assigned to the wrong VLAN.
S2 has the wrong IP address assigned to the VLAN30 interface.

13
A system administrator must provide Internet connectivity for ten hosts in a small remote office. The ISP has assigned two public IP addresses to this remote office. How can the system administrator configure the router to provide Internet access to all ten users at the same time?

Configure DHCP and static NAT.
Configure dynamic NAT for ten users.
Configure static NAT for all ten users.
Configure dynamic NAT with overload.


14
Refer to the exhibit. From the output of the show interfaces and ping commands, at which layer of the OSI model is a fault indicated?

application
transport
network
data link
physical

15
Refer to the exhibit. Results of the show vlan and show vtp status commands for switches S1 and S2 are displayed in the exhibit. VLAN 11 was created on S1. Why is VLAN 11 missing from S2?

There is a Layer 2 loop.

The VTP domain names do not match.

Only one switch can be in server mode.

S2 has a higher spanning-tree priority for VLAN 11 than S1 does.

16
Refer to the exhibit. What is the effect of the extended ACL when applied inbound on the S0/0/0 interface on R2?

All IP traffic will be permitted during the specified days and time range.

Both IP and Telnet traffic will be permitted during the specified days and time range.

Only Telnet traffic destined for 172.16.10.0/24 will be permitted during the specified days and time range.

Telnet traffic will be permitted only during the specified days and time range. All other network traffic will be permitted any time.


17
Which three guidelines would help contribute to creating a strong password policy? (Choose three.)

Once a good password is created, do not change it.
Deliberately misspell words when creating passwords.
Create passwords that are at least 8 characters in length.
Use combinations of upper case, lower case, and special characters.
Write passwords in locations that can be easily retrieved to avoid being locked out.
Use long words found in the dictionary to make passwords that are easy to remember.

18
Refer to the exhibit. How is the TCP/IP configuration information specified by the default-router and dns-server commands made available?

The TCP/IP information is forwarded to a 10.0.1.3 to be supplied to DHCP clients.

The TCP/IP information is used by DNS clients to forward all data to the default gateway on R1 of 10.0.1.3.

The TCP/IP information is supplied to any DHCP client on the network connected to the FastEthernet 0/0 interface of R1.

The TCP/IP information is applied to each packet that enters R1 through the FastEthernet 0/0 interface that are hosts on the 10.0.1.0 /24 network except packets from addresses 10.0.1.2, 10.0.1.16, and 10.0.1.254.


19
Which variable is permitted or denied by a standard access control list?

protocol type
source IP address
source MAC address
destination IP address
destination MAC address

20
When configuring a Frame Relay connection, what is the purpose of Inverse ARP?

to assign a DLCI to a remote peer
to disable peer requests from determining local Layer 3 addresses
to negotiate LMI encapsulations between local and remote Frame Relay peers
to create a mapping of DLCI to Layer 3 addresses that belong to remote peers

1 comment:

Andria BZ said...

I have completed CCNA certification, now I am looking the job opportunity in IT industry, here I had useful tips to get a good career thanks for sharing & I have an expectation about your future blog so keep blogging.
Regards,
ccna training in Chennai